I cannot get CRT to save the New line mode setting under Session Options/Emulation/Modes. Any suggestions?

When you are connected, CRT displays the current "New Line Mode" setting. This setting is either the initial value or could have been changed by the remote system sending an escape sequence to change the mode. CRT does not save the current setting. CRT only saves the initial setting.

Under CRT 1.1.4, the initial "New Line Mode" setting can be set by editing the session from the connect dialog.

Under CRT 2.0, the initial "New Line Mode" setting can be set by clicking the "Advanced" button on the emulation tab of the Session Preferences dialog.